Publicidad
Idiomas disponibles
Idiomas disponibles
10.1 TORSO ADJUSTER TYPE AND OPERATION
Safewaze FBHs utilize 3 types of adjusters (adjuster type depends on harness model). Figure 7 indicates the Torso Adjuster options available and the
proper operation of each type.
QUICK TORSO ADJUSTER
FRICTION
TORSO ADJUSTER
MATING BUCKLE
TORSO ADJUSTER
FIGURE 7 - TORSO ADJUSTER OPERATION
To operate the Quick Torso Adjuster:
Step 1:
Push down on the Quick Adjuster tab which releases tension on the torso
strap webbing.
Step 2:
Pull up on the free end of the torso strap to shorten, or push downward on
the Quick Torso Adjuster to lengthen the FBH torso straps.
Step 3:
Release the Quick Adjuster tab once torso strap is proper adjusted and
stow excess webbing with the elastic webbing keeper.
To operate the Friction Torso Adjuster:
Step 1:
Pull on the free end of the torso webbing to tighten the strap. Loosen the
strap by pulling on the free end of the strap and then back the webbing
through the Friction Adjuster.
Step 2:
Release the webbing and stow excess webbing with elastic webbing
keeper.
To operate the Mating Buckle Torso Adjuster
Step 1:
Adjust the webbing length of the male buckle to approximate required
length
.
Step 2:
Insert the Male Buckle through the slot in the Female Buckle.
Step 3:
Tighten the free end of the strap so that the Male Buckle is seated securely
in the Female Buckle.
Step4:
Stow excess webbing with elastic webbing keeper.
V2.0 2022 Copyright Safewaze
User Manual
6
Publicidad
