SafeWaze 018-1000 Manual Del Usuario página 17

16.2 9013 BEHIND THE WEB BRACKET
The 9013 bracket comes fully assembled and ready for installation. No tools are required for installation of the bracket
onto harness. Use the following instructions and Figure 12 to install the 9013 Behind the Web Bracket.
To Fasten To Harness:
1. Ensure that the curved portion of 9013 is in a downward orientation relative to the harness
(See Figure 12, Dwg. 1).
2. Simultaneously depress both locking button (A) and and slide lock (B) (See Figure 12, Dwg. 2) to swing the
bracket open (See Figure 12, Dwg. 3).
3. With the bracket open, install dual leg retractables onto the bracket via the swivel tops of each. Swivels
should be hanging on the curved portion of bracket.
4. Slide the bar behind both loops of webbing at dorsal D-ring. Swing the bracket closed until it locks into place.
5. Check the locking function of the bracket by attempting to swing the bracket open WITHOUT depressing
locking button (A) or slide lock (B). Bracket bar should not move and the bracket is now locked into place.
6. Dual leg retractables can be easily installed and removed from bracket by once again depressing both locking
button (A) and slide lock (B), which allows bracket to swing open without complete removal from harness.
Bar assembly of bracket which inserts behind
webbing at dorsal D-ring
2
SLIDE TO OPEN
Dwg. 1
9013 in opened
configuration
2
SLIDE TO OPEN
Dwg. 3
FIGURE 12 - 9013 DUAL BRACKET INSTALLATION
1
PUSH
Curved Portion of 9013
1
PUSH
V2.0 2022 Copyright Safewaze
Slide Lock (B)
2
SLIDE TO OPEN
Dwg. 2
9013 correctly
installed at Dorsal D-ring of harness
2 SLIDE TO OPEN
Dwg. 4
User Manual
Locking Button (A)
1
PUSH
1
PUSH
11