Publicidad
Idiomas disponibles
Idiomas disponibles
15.0 DONNING AND ADJUSTING THE HARNESS
Safewaze harnesses are offered in a variety of configurations, which can include mating buckle or quick-connect buckles,
and some styles which offer tongue buckle leg adjustment. The following sequence of steps in donning the harness are
correct regardless of harness configuration. See Figure 10 for illustration of steps.
Step 1: Disconnect chest and leg buckles. If so equipped, also disconnect the waist belt buckle. Hold the FBH by the
dorsal D-ring allowing the harness to hang freely. Ensure that harness is not twisted or tangled.
Step 2: Slip arms in arm openings as you would if donning a vest.
Step 3: Adjust length of the leg straps to a point that will provide a snug fit. Connect the leg buckles
(Mating Buckle or Quick Connect) and again ensure snug fit of the leg strap. In the event your harness is
equipped with Grommet Legs, pull the free end of the webbing through the buckle assembly until proper fit
is achieved. Insert the tongue of the buckle assembly through the leg strap grommet, and thread the free
end of the leg strap through the plastic and web keepers to secure excess webbing.
Step 4: Adjust chest strap to a location just under the sternum. Shorten or lengthen the chest strap to provide a snug fit
across the chest. Connect the chest buckle (mating buckle or quick-connect) and once again ensure
proper placement and tension of the strap (See Figure 6 for mating buckle operation).
Step 5: If FBH is equipped with a waist belt, adjust length in same manner as tongue buckle legs and fasten for snug fit.
15.1 DON AND ADJUST CROSSOVER STYLE HARNESS
Step 1: Hold both shoulder straps of the harness in your left hand. Slide the shoulder straps over the left shoulder. With
both straps still on the left shoulder, take the right shoulder strap and slide over top of head to right shoulder.
Step 2: The harness is properly positioned on the body when the head is centered between the shoulder pads with
the fall arrest attachment positioned in the upper middle portion of the back, between the shoulder blades. The front
attachment point should be centered on the sternum of the user.
Step 3: Connect leg buckles in the same manner as a standard Full Body Harness.
FIGURE 10 - HARNESS DONNING
2
1
V2.0 2022 Copyright Safewaze
4
3
"CLICK"
User Manual
5
9
Publicidad
