Publicidad
Idiomas disponibles
Idiomas disponibles
USE :
"ON / OFF" COMMAND
- This command is used to switch the appliance on or to put it on standby.
- After commissioning, the device enters ventilation mode and displays the room
temperature.
- When you stop the air conditioner, wait 3 minutes before restarting it.
MODE CONTROL
Select the desired mode by pressing
comes on:
Air conditioning
Dehumidification
Ventilation
"AIR CONDITIONING" MODE
- The ambient air is cooled and then expelled into the room, and the hot air is expelled to
the outside through the exhaust pipe.
- Using the buttons on the control keypad, select the desired temperature in the room and the
ventilation speed according to your needs and the desired level of comfort.
- In Cooling mode, the display shows the target temperature.
Remark : In "Air conditioning" mode, the air exhaust pipe must expel the hot air to the
outside.
- When the ambient temperature is lower than the programmed temperature, the
appliance will automatically operate in ventilation mode.
- The cooling function starts again as soon as the room temperature exceeds the
programmed temperature.
- The temperature range is 16 ° C to 32 ° C.
"DEHUMIDIFICATION" MODE
- When the "Dehumidification" mode is selected, the indicator
speed is fixed at slow.
- The display shows the room temperature.
- The "Timer" function can also be selected, but not the "Sleep" mode.
Remark :
In "Dehumidification" mode, the appliance does not need a
drain hose.
Be sure to keep windows and doors closed.
Continuous drainage can be achieved by connecting a
drainage hose to the back of the unit. (G point)
to the desired mode. The corresponding indicator light
EN-20
lights up. The fan
Publicidad
