Publicidad
Idiomas disponibles
Idiomas disponibles
HOLZMANN Maschinen GmbH
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
www.holzmann-maschinen.at
4.
Sliding table
Place the sliding table (1) on the machine and fix it
at the fixing points (2) using screws, spring washers
and washers (3). Do not tighten the screws before
adjusting of the sliding table is finished.
Level the edge of the sliding table with that of the
work table (using a spirit level) until it is
horizontally aligned without gaps.
NOTE:
Over the entire length, the distance between
the two table edges must be within 12mm.
Furthermore, it should be aligned exactly to the rip
fence / saw blade.
Then tighten the screws.
5.
Sliding table support/end handle/handle
Fix the support (1) on the end of the sliding table
with 4 screws, spring washers and washers as
shown
Adjust the height (4) with the set screw
Fix end handle with 4 screws
Hook handle (3) in desired position and fix it with
clamping lever
6.
Outrigger table
Place the bracket of the outrigger table (1) on the
sliding table as shown.
Place the holder of the outrigger table on the
swivel arm support (2).
Tighten the clamping lever (3) of the outrigger
table to fix the position.
Adjust the horizontal alignment with the adjusting
screws (4).
Insert the pivot mount of the crosscut fence (5) into
the front or rear hole of the outrigger table and fix
it with clamping 90° (6)
Insert the groove stone of the support fixing into
the opening, push the groove stone into the
groove of the support (7) and fix it in the desired
position with the fixing screw (8).
Push the flip stops (9) into the groove of the cross
cut fence
Fix the magnifiers (10) with screws
7.
Mitre gauge
Place the bracket mitre gauge (2) on the sliding
table as shown.
Remove the groove stone (3) of the bracket and
slide it into the groove of the mitre gauge
Refix the mitre gauge with the screw (4) on thge
groove stone to the bracket
Fix mitre gauge with clamping screw mitre gauge
(5) in the thread in sliding table
Fix mitre gauge (1) in desired position with
clamping lever (6)
Push the flip stops (7) into the groove of the cross
cut fence
Fix the magnifiers (8) with screws
ASSEMBLY
48
FKS400V32PRO_400V
Publicidad
