NETTUNO 20
EMI CLASSIFICATION
According to the standards EN 55032 and 55035 this is a class B equipment, designed
and suitable to operate in residential environments.
FCC CLASS B STATEMENT ACCORDING TO TITLE 47, PART 15, SUBPART B, §15.105
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference
in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
WARNING
Make sure that the device is securely installed in a stable position to avoid any injuries or
damages to persons or properties.
Before installing the device check all the components for damages, deformations, missing
or damaged parts that may compromise safety during installation.
Follow the instructions in this user manual to properly install the device. It's suggested to
keep enough distance from other devices to allow the right cooling.
The warnings in this manual must be observed in conjunction with the "USER – MANUAL
- Section 2".
2