ZKTeco ML200 Manual De Usuario página 5

Step 2
Open the ZSmart App, register and sign in to the account.
Step 3
Make sure the lock is in Factory Default Mode. Turn on Bluetooth permission on your
smartphone, and stay near the lock (within 10 meters without obstacles).
Step 4
Tap the "+" button on the upper right corner, follow the on-screen instructions to pair the
lock automatically, and start to use it.
Programming the Lock in Standalone Mode
3
It is recommended to use ZSmart App to program your lock. If you don't have a
smartphone or don't want to use the App, you can use the programming instructions
below.
Note:
1)
Standalone Mode is not available after the lock is registered in App! Please
reset the lock to Factory Default Mode first to program your lock in
Standalone Mode.
2) Admin must be created before any other programming. Only one Admin is
available in the Standalone Mode.
3.1 Add the Admin Password in Standalone Mode
Press and hold the ZKTeco Button for
3 seconds
Enter a six-digit password and press
ZKTeco Button
Enter the same six-digit password
and press ZKTeco Button again
Operation
Completed
Indicator's Status
2 short beeps with flashing green
light
1 short beep with green light, then
flashing green light
1 short beep with green light
2 short beeps with no light indication
3