Publicidad
automatically turn off not later than in 2 (two) minutes. After each use, wash
the device and the used nozzles as indicated in the "Maintenance" section
(clause "Daily Care").
NOTE. It is not recommended to use the nozzle (16) in the "Light" mode to avoid
damage to periodontal pockets.
Maintenance
Daily maintenance. Open the filler cap (10) and drain off any water remaining
in the tank. Disconnect the nozzle as shown in figure e. Rinse the tank and
nozzles in warm running water, without detergents or cleaning agents, and
dry thoroughly.
Total care. A total cleaning of the water tank must be performed once a
week. To do this, disconnect the tank as shown in picture f. Wash it inside
and outside in warm running water with a soft brush or sponge, without
detergents or cleaning agents, and dry thoroughly.
Troubleshooting
The device does not turn on. Possible reason: the battery is low. Solution:
charge the device for at least 4.5 hours.
The device does not supply water. Possible causes: the nozzle's outlet is
clogged, the water tank is out of water. Solution: fill the tank with water, clean
the nozzle's outlet.
Operating time after a full charge is less than 10 minutes. Possible reason:
the battery does not hold charge. Solution: contact the service centre to
replace the battery of the device.
WARNING! If none of the suggested solutions solves the problem, contact your
supplier or service centre. Do not disassemble or attempt to repair the device
by yourself.
aeno.com/documents
15
Publicidad
