Publicidad
Idiomas disponibles
Idiomas disponibles
Note:
The amount of refrigerant used by the freezer is specified on the appliance marking.
2. Installation instructions
-
Before installation, please read the instructions carefully to avoid any problems.
-
Figure 2 shows the dimensions of the mounting space.
-
Place the freezer on a solid, flat surface to keep it stable, otherwise vibrations and noises
will occur. When the freezer is placed on a carpet, straw mat, or polyvinyl chloride, solid
support plates should be placed under the freezer to avoid colour change due to heat
dissipation.
It is necessary to maintain unobstructed ventilation around the appliance or in the
-
structure where it is installed .
3. Reversing the freezer door
The opening side of the door can be changed from the right side to the left side if the
-
location of the appliance requires it.
Warning! Be careful when reversing the door.
-
The appliance must not be connected to a mains socket. Make sure it is unplugged from
-
the power supply.
Necessary tools (not included).
-
a. Crosshead screwdriver.
b. Flat-head screwdriver.
Fixed spanner 8 mm.
c.
NOTE: When necessary, tilt the freezer backwards to gain access to the base, the appliance
should be placed on soft foam packaging or similar material to avoid damaging the back of
the freezer. To reverse the door, the following steps are generally recommended.
1. Place the appliance upright. Open the door and remove the top hinge protector (left and
right). Remove the bottom screw hole protector from the freezer. Remove the door screw
hole protector (Fig. 3).
2. With the door closed, remove the screws on the outside of the hinges. Open the door
hinges. With the hinge open, loosen the screws securing it to the freezer. Be careful with
the hinge, use a long shaft screwdriver if possible (Fig.4).
3. Remove the hinge and place it in the diagonally opposite corner of the freezer. Screw it
back on. Repeat with the other hinge. Refit the door and refasten the hinges. Check that
the door is aligned horizontally and vertically and that the seals are closed and securely
in place on all sides before tightening the bottom hinge screws (Fig. 5).
4. Replace the upper hinge protector (left and right). Replace the cover of the freezer's
lower screw hole. Replace the door screw hole cover (Fig. 6).
ENGLISH
Bolero CoolMarket TF B1 101 E
57
Publicidad
