(continued)
3
Slide Head Track
Retainer tight
tight
to Side
Jamb.
Position Head Track Retainer tight to side jamb and snap into kerf using a rubber mallet and wood block.
9 2 0 5707
1/8" holes
·
Protect surfaces from tool contact.
Failure to do so could result in
surface marring or product damage.
This area intentionally left blank.
12
NOTICE
Snap into kerf
and fully seat
using a rubber
mallet and
wood block.
1
st
A-Series
A-Series
No Fastener Required
2
nd