Publicidad
Idiomas disponibles
Idiomas disponibles
cegard/Smart
5.14 Technical data cegard/Smart control unit
Mechanical
Dimensions (w × h × l)
Housing material
Color
Enclosure rating
Temperature range
- Operation
Electrical
Supply voltage U
SP
Output voltage to light curtain 12 VDC
Max. power-up time
cegard/Smart control unit
Average power consumption 20 W
Output
Max. relay current
cegard/Smart control unit
output :
- UL rated contact
- TÜV
Max. number of mechanical
relay operations
Typical system response time < 130 ms
Connectors (plugs)
Light curtain
(plugs already connected at connection cables)
- cegard/Smart Tx
- cegard/Smart Rx
Control unit (plug is connected to PCB)
- Power / output
* or or equivalent
© CEDES | V 1.0
280 × 200 × 80 mm
(11.024 × 7.874 ×
3.149 in.), see Chapter 7
ABS thermoplastic
(UL 94-HB rated)
Light gray
IP20
-30 °C ... +60 °C
(-22 °F ... +140 °F)
100 ... 240 VAC
< 2 s
Relay
12 A at 125 VAC,
8 A at 28 VDC
6 A at 250 VAC,
6 A at 28 VDC
> 10 ×10
6
White, 6-pin,
WAGO 734-106 (*)
White, 6-pin,
WAGO 734-106 (*)
Orange, 6-pin,
WAGO 231-306 (*)
General
EMC emmision
EMC immunity
Vibration
Shock
RoHS, REACH
Certificates
- USA / Canada
• CSA
• FCC
- Europe
• CE
** NOTE:
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and
receiver.
Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV
technician for help).
EN 12015:2014
EN 12016:2013,
ISO 22200:2009
IEC 60068-2-6:2007
IEC 60068-2-27:2008
2011/65/EU, 1907/2006 EU
CSA B44.1:19 /
ASME A17.5-2019
Class B (**)
2014/30/EU, 2014/33/EU
English
11
Publicidad
