Publicidad
Idiomas disponibles
Idiomas disponibles
cegard/Smart
Mark the mounting holes.
Apply double-sided tape (EU) or felt strip (NA) to the
middle of the light curtain (refer also to Figure 13).
Make sure that the door surface is clean where the tape
or felt strip is located.
Drill the holes for mounting on the marked positions.
© CEDES | V 1.0
Mount the edge with the screws from the side in the
drilled holes.
For Tx repeat:
1.1 – 1.3
2
3
Connection cable
Connect the connection cable (blue plug) on the
receiver edge and guide the cable to the control unit.
English
Blue plug
M8, 6 pin
15
Publicidad
