EGO PRO X LMX5300SP Manual página 15

◾
◾
◾
◾
The mower unexpectedly
stops while mowing.
◾
◾
◾
◾
◾
There is excessive ◾
vibration.
◾
◾
◾
The motor works but the
blade doesn't cut the
grass.
WARRANTY
EGO WARRANTY POLICY
Please visit the website egopowerplus.eu for full terms and conditions of the EGO Warranty policy.
The battery pack(s) charge is depleted.
Mower is overloaded and the mower status
indicator flashes orange.
Mower deck is clogged with grass and debris.
The battery pack(s) or mower circuitry is
too hot. If the battery pack is overheated the
mower status indicator goes off. If the mower
is overheated the mower status indicator glow
solid orange.
The blade speed mode is not set properly.
The mower electronics error and the mower
status indicator flashes red/green alternately.
The cutting blade is loose.
The cutting blade is unbalanced.
The cutting blade is bent.
The motor shaft is bent.
The mower is set to cut too much grass at
once.
The blade speed mode is not set properly.
The blade is not tightened to the required
torque.
56 VOLT LITHIUM-ION CORDLESS MOWER — LMX5300SP
◾
Charge the battery pack.
◾
Check if grass has accumulated
beneath the deck and clean if
needed. Raise the cutting height or
slow down the mowing.
◾
Unclog the mower deck. Raise
the cutting height and/or cut a
narrower swath.
◾
Allow the battery pack(s) or mower
to cool down.
◾
Clean the air intake, following
the section "Cleaning the Air
Intake"
◾
Select the blade speed to a lower
setting.
◾
Contact EGO Service Center.
◾
Tighten the blade bolt.
◾
Contact the EGO Service Center.
◾
Replace the blade.
◾
Contact the EGO Service Center.
◾
Raise the deck to a higher cutting-
height setting.
◾
Set the blade speed to a lower
setting.
◾
Re-tighten the blade. The
recommended torque for the blade
bolt is 50-60 Nm.
15
EN