ErgoAV ERMMM6-01B Manual De Instrucciones página 10

Step 2 Attach the Arm Assembly / Wall Plate to the Wall
For wood stud installation, follow STEP 2A.
For concrete installation, follow STEP 2B.
Step 2A Wood Stud Option
WARNING:
● DO NOT use a drill for tightening the Lag Screws [A1]! Only use a Socket Wrench.
● To avoid potential personal injury or property damage, DO NOT over-tighten the
Lag Screws [A1]. Tighten the Lag Screws [A1] only until they are pulled firmly
against the Wall Plate [02] and the wall.
● DO NOT USE THE ANCHOR [A2] FOR THIS STEP.
● Ensure the Wall Plate [02] is securely fastened to the wall before
continuing to the next step.
● Nominal wood stud size: Should be 2" x 4" (51mm x 102mm).
● Stud center must be verified.
2A-1
2A-2
OR
03
Use a Stud Finder to locate wood
studs or use an Awl to verify the
edges. Mark the edge and center
locations.
Position the Wall Plate Template
[03] at your desired height and line up
the holes with your stud center line.
Level the Wall Plate Template [03] and
mark the holes.
09
X
Anchor
Awl
Stud Finder
(Not lncluded)
(Not lncluded)
Pencil
(Not Included) (Not Included)
Wall
A2
Level