ErgoAV ERMMM6-01B Manual De Instrucciones página 11

2A-3
2A-4
A1
Step 2B Solid Concrete Wall Option
WARNING:
● DO NOT use a drill when tightening the Lag Screws [A1]! Only use a socket wrench.
● To avoid potential personal injury or property damage, DO NOT over-tighten the Lag
Screws [A1]! Tighten the Lag Screws [A1] only until they are pulled firmly against the
Wall Plate [02] and the wall.
● Ensure the Wall Plate [02] is securely fastened to the wall before continuing to the
next step.
● Mount the Wall Plate [02] directly onto the concrete surface without
any covering.
● The thickness of the concrete wall must exceed 5 1/2" (140mm).
Drill 4 pilot holes using a 7/32"
(5.5mm) diameter drill bit. Make sure
the depth is not less than 2 3/4"
(70mm) deep.
2 3/4" (70mm）
NOTE: DO NOT use a drill to tighten the
Lag Screws [A1]. Only use a socket wrench.
Install the Wall Plate [02] using the Lag
Screws [A1]. Using self-supplied 1/2"
(13mm) socket wrench, tighten the Lag
Screws [A1] until the Lag Screws [A1] are
pulled firmly against the Wall Plate [02].
02
DO NOT over-tighten the Lag Screws [A1].
10
Electric Drill
(Not Included)
1/2" (13mm)
Level Socket Wrench
(Not Included) (Not Included)
Wall
Anchor
A2