Ego Power+ HPW2000E Manual página 14

EN
TROUBLESHOOTING
PROBLEM CAUSE
◾
The pressure
washer fails to be
◾
powered on.
◾
The TURBO speed
could not be
activated.
◾
The pressure
washer pump
◾
stops working and
the speed indicator
◾
on the washer
flashes three
green lights.
◾
◾
◾
◾
◾
The water flow
is low during ◾
spraying.
◾
◾
14
56V LITHIUM-ION PRESSURE WASHER — HPW2000E
Battery pack charge is low.
Battery pack is not installed properly.
Only one battery pack is used for the washer
operation.
The pressure washer or the battery pack(s)
are over temperature.
The nozzle is blocked.
No water flows into the siphon hose.
Battery pack charge is low.
Other electronic fault(s).
The filter is blocked partially.
The metal mesh in the water inlet port is
blocked partially.
The filter and quick-coupler joint of the
siphon hose is not fully immersed into water.
The siphon hose is folded.
Water is dirty.
The high-pressure hose is blocked.
SOLUTION
◾
Charge the battery pack.
◾
Slide the battery pack into the battery
compartment until it snaps into position.
◾
Use two 5.0Ah or greater Ah battery
packs.
◾
Wait until the pressure washer or
battery pack(s) return to the operating
temperature and then restart the
washer.
◾
Use the nozzle cleaning needle to pass
through the holes.
◾
Check and ensure there is water flowing
into the siphon hose properly.
◾
Charge the battery pack.
◾
Contact EGO customer service.
◾
Clean the filter.
◾
Remove and clean the metal mesh.
◾
Fully immerse the filter and quick-
coupler joint into water.
◾
Unfold the siphon hose or replace it.
◾
Use only clean water.
◾
Remove the nozzle, and then start water
spraying from the hose to clear the
blockage of the hose.