Ego Power+ HPW2000E Manual página 15

PROBLEM CAUSE
◾
There is no water supply.
◾
The filter is blocked completely.
◾
The metal mesh in the water inlet port is
There's no water
block completely.
spraying out.
◾
The nozzle is blocked.
◾
Pump, hoses, or other components are
frozen.
◾
Air flows into the washer.
The water flow is
not stable. ◾
Pump seals are worn.
◾
The high-pressure hose is damaged.
The water spraying
◾
There's water leakage from the gun.
starts or stops
automatically.
◾
Pump seals, hose seals are worn.
◾
The position of the gun is beyond wireless
connection range.
◾
The coin cell (button cell) battery charge
is low.
The gun cannot
◾
The gun is not paired properly.
control the washer.
◾
Coin cell battery is not installed properly.
WARRANTY
EGO WARRANTY POLICY
Please visit the website egopowerplus.eu for full terms and conditions of the EGO Warranty policy.
SOLUTION
◾
◾
◾
◾
◾
◾
◾
◾
◾
◾
◾
◾
◾
◾
56V LITHIUM-ION PRESSURE WASHER — HPW2000E
Check and ensure the washer is
connected to the water supply properly.
Clean the filter.
Remove and clean the metal mesh.
Use the nozzle cleaning needle to pass
through the holes.
Wait until they are thawed.
Check and ensure the siphon hose is
connected properly.
Contact EGO customer service.
Replace with new high-pressure hose.
Contact EGO customer service.
Contact EGO customer service.
Take the gun closer to the pressure
washer.
Replace with a new coin cell
(button cell) battery.
Complete the pairing following
the instructions in the section
"Short Pressure Gun Pairing".
Install the coin cell battery following the
instructions in the section "REPLACING
THE COIN CELL BATTERY".
EN
15