Publicidad
Idiomas disponibles
Idiomas disponibles
4. Fit the new flat fold filter. During in-
sertion, ensure that the flat fold filter
is flush on all sides.
5. Insert the filter frame.
6. Close the filter cover until it audibly
latches into place.
Change the candle filter
1. Open the filter cover.
2. Take out the candle filter.
3. Insert the new candle filter.
Illustration D
4. Close the filter cover until it audibly
latches into place.
Changing the fleece filter bag
1. Unlock and remove the suction
head.
2. Pull the fleece filter bag out to the
rear.
Illustration H
3. Fold in the lock latch and seal the
fleece filter bag tight.
4. Fit the new fleece filter bag.
5. Fit and lock the suction head.
Changing the dust bag
1. Unlock and remove the suction
head.
2. Fold up the dust bag.
Illustration I
3. Pull the dust bag opening towards
the rear over the suction hose port.
4. Seal the dust bag tightly underneath
the opening using cable ties.
5. Remove the dust bag.
6. Fit the new dust bag.
7. Pull the dust bag over the container.
8. Fit and lock the suction head.
Cleaning the electrodes
1. Unlock and remove the suction
head.
2. Clean the electrodes with a brush.
3. Fit and lock the suction head.
Troubleshooting guide
DANGER
Danger of electric shock
Injuries due to touching live parts
Switch off the device.
Remove the mains plug.
Suction turbine does not start up
1. Check the socket and the power
supply fuse.
2. Check the mains cable, mains plug,
electrodes and power socket on the
device.
3. Switch on the device.
Suction turbine switches off
1. Empty the container.
Suction turbine does not switch on
again after emptying the container
1. Switch off the device and wait for 5
seconds. Switch on the device.
2. Clean the electrodes with a brush.
Suction force decreases
1. Remove obstructions from the suc-
tion nozzle, suction pipe, suction
hose or flat fold filter / candle filter.
2. Change the filled fleece filter bag.
3. Dispose of the filled dust bag.
4. Correctly engage the filter cover.
5. Change the flat fold filter or candle
filter.
6. Check the drain hose for leaks.
Escaping dust when vacuuming
1. Check that the flat fold filter is cor-
rectly fitted and correct if necessary.
Illustration P
2. Change the flat fold filter or candle
filter.
The automatic switch-off mecha-
nism (wet vacuum cleaning) does
not trigger
1. Clean the electrodes with a brush.
2. Continuously monitor the filling level
when vacuuming non-conductive
liquids.
English
13
Publicidad
