Contents
IMPORTANT SAFETY INSTRUC-
TIONS ................................................
General notes ....................................
Environmental protection ...................
Hazard levels .....................................
Intended use ......................................
Description of the device....................
Preparation ........................................ 10
Initial startup....................................... 10
Operation ...........................................
Transport............................................ 12
Storage .............................................. 12
Care and service................................ 12
Troubleshooting guide........................ 13
Warranty............................................. 14
Accessories and spare parts.............. 14
Technical data .................................... 15
IMPORTANT SAFETY
INSTRUCTIONS
READ ALL INSTRUCTIONS BE-
FORE USING THIS MACHINE
● Inform your dealer immediately if
there is any shipping damage.
● Completely remove the accessories
from the box.
● The machine is not suitable for suck-
ing up hazardous dusts as asbestos.
● Only operate the vacuum from a
grounded outlet. Refer to the Tech-
nical data for the necessary main
fuse.
● CONNECT VACUUM CLEANER
WITH PROPERLY GROUNDED
OUTLET ONLY. See Grounding In-
structions.
SAVE THESE INSTRUCTIONS
This vacuum is intended for com-
mercial use.
SAFETY INSTRUCTIONS
When using an electrical machine, ba-
sic precautions should always be fol-
lowed, including the following:
6
1 DISCONNECT VACUUM CLEAN-
ER FROM POWER CIRCUIT before
removing the cover, performing
6
maintenance work, and when not in
8
use.
8
9
2 DO NOT LEAVE the machine unat-
9
tended when plugged in.
9
3 ALWAYS CHECK THE POWER
SUPPLY CORD for damage or signs
of any aging before each use.
11
4 DO NOT PULL OR CARRY VACU-
UM CLEANER BY CORD. Do not
close door on cord or pull cord
around sharp edges.
5 KEEP CORD AWAY FROM HEAT
AND OIL. Do not leave cord lying
around after job is complete. It can
become a tripping hazard.
6 DO NOT RUN VACUUM OVER
CORD.
7 TURN SWITCH TO OFF before un-
plugging power supply cord.
8 DO NOT UNPLUG BY PULLING
CORD. To unplug, grasp plug, not
cord.
9 DO NOT GRASP PLUG WITH WET
HANDS.
10A DAMAGED CORD OR PLUG
should only be replaced by an au-
thorized service center representa-
tive. DO NOT ATTEMPT TO
REPAIR POWER CORD.
11 TO AVOID SHOCK, do not expose
to rain. Store indoors.
12USE ONLY AS RECOMMENDED
BY THIS MANUAL. Use only with
recommended attachments.
13KEEP HAIR, CLOTHING, LOOSE
JEWELRY, FINGERS and all parts
of the body away from openings and
moving parts.
14DO NOT BLOCK OR OBSTRUCT
OPENINGS. Keep openings free of
lint, hair, dust, and anything that re-
stricts air flow.
English