Ego Power+ PAD5000E Manual página 6

PACKING LIST (FIG. A1)
EN
DESCRIPTION
KNOW YOUR INVERTER (Fig. A1)
1. LED Lights
2. Handle
3. Battery-Release Button
4. Ejection Mechanism
5. Electric Contacts
6. Latch
7. AC Output Port (type varies region)
8. USB-A Output
9. USB-C Port 1 (Output)
10. USB-C Port 2 (Input / Output)
11. LED Button
12. Power Button
OPERATION
APPLICATIONS
◾
Supplying power for small AC devices (up to 400W).
Pure Sine Wave Inverter makes AC power suitable for
even most sensitive electronics.
◾
Supplying power to compatible USB electronics up to
18W via USB-A or USB-C port 1, or 100W via USB-C
port 2, such as cell phones, tablets, laptops.
◾
Charging the EGO battery using the inverter USB-C
input/output port 2, such as compatible USB PD
chargers.
◾
Providing light in low light conditions or emergency
backup.
ATTACHING/DETACHING THE BATTERY PACK
Use only with EGO's battery packs and chargers listed in
Fig. A2.
Fully charge before first use.
To attach
Align the battery ribs with the mounting slots and press the
battery pack down until you hear a "click" (Fig. B1).
To detach
Depress the battery-release button and pull the battery
pack out (Fig. B2).
6
56 VOLT POWER INVERTER — PAD5000E
STARTING/STOPPING THE POWER INVERTER
(Fig. C)
To start
Press and hold the power button for more than one
second. The button will illuminate green to indicate that
the power inverter is active.
NOTE:
The inverter will start automatically when a USB-
PD compatible charger is connected.
To stop
Press and hold the power button for more than one
second again. The green light will be off to indicate that
the power inverter is deactivated.
NOTE:
When connecting a DRP (Dual Role Port) device,
the inverter may start automatically again after the
inverter is turned off.
C-1 Power Button
LED LIGHTS (Fig. D)
To use the LED lights, press the LED button to scroll
through the following light modes:
◾
Low brightness mode
◾
High brightness mode
◾
LED lights are turned off
In any mode, press and hold the LED button for more
than 1 second and the lights will switch into flashing,
"EMERGENCY" mode. Press the LED button again, the
lights will shut off.
NOTE:
The power inverter must be turned ON for the LED
lights to function.
D-1 LED Button D-2 LED Lights