Publicidad
Idiomas disponibles
Idiomas disponibles
Storage and transport lock
This generator is equipped with a storage
and transport lock that locks the iron to the
base of the generator.
To use the generator, slide the storage lock
downwards, releasing the iron.
To block the iron at the base of the
generator, fit the iron into the rear lock on
the generator base and slide the storage
latch upwards until it clicks.
NOTE – let the iron cool down completely
before locking it to the generator base.
Cable organizer
When not in use, the power cable and the
steam supply hose may be stored in the
base of the appliance.
OPERATING INSTRUCTIONS
Before first use
Remove any sticker, protective film or
storage card from the base, except the
technical data plate.
Fill the water tank with water, heat the iron
to the maximum temperature and iron a
piece of damp cloth for several minutes to
remove any residues from the base.
NOTES:
- It is normal for there to be a strange odor
coming from the appliance the first time
you use it. This odor disappears after a
short time.
- It is possible that some particles come
out of the base when using the iron for the
first time. This is normal. The particles are
harmless and will stop coming from the iron
shortly.
20
- When plugging in the appliance, the iron
may emit a pumping sound This is normal.
The sound indicates the water is being
pumped from the base to the iron.
- During the heating process, a small
amount of steam may come from the base,
which will stop after a few seconds.
Use
Filling the water tank
Grasp the handle of the water tank and
remove the tank, pulling it horizontally.
Fill the tank through the opening. We
recommend using tap water or water with
less limestone particles. The maximum
capacity of the water tank is 1.1 liters and
the water level must not exceed the "MAX"
mark.
Replace the water tank correctly on the
base of the generator.
The appliance has two ironing methods.
You may use dry ironing or steam ironing.
Dry ironing
Place the appliance on a stable, flat surface.
Always place the iron on the heat insulating
stand.
Connect the plug to the wall socket; the
device turns on.
Turn the temperature knob to the desired
setting, which depends on the fabric of the
garment; the temperature indicator lights
up and the iron starts to heat up.
When the temperature indicator turns off,
it means the selected temperature has
been reached. Now you may begin ironing.
WARNING: never touch the hot base before
it has cooled down!
www.flama.pt
Publicidad
