Publicidad
Idiomas disponibles
Idiomas disponibles
Original accessories/auxiliary
equipment
■
Use only the additional equipment and accesso-
ries specified in the operating instructions. Using
attachments or accessory tools other than those
recommended in the operating instructions can
lead to a risk of injury.
Before use
Setting up the appliance
Fix the appliance using suitable bolts (not included
in delivery) to a flat, stable base. Use the drill
holes
for this purpose. Ensure that a mains
socket is within easy reach.
NOTE
►
In exceptional cases you can position the
baseplate for this process on a solid support.
Removing/inserting transport
safety devices
Removing transport safety devices
♦
Apply a little pressure to the handle
pull the transport safety device
motor unit
can now be moved upwards.
Inserting transport safety devices
♦
Press the handle
transport safety device
The motor unit
is now fixed.
NOTE
►
Use the transport safety device for trans-
porting the appliance. Carry the appliance
by its integrated carrying handle
│
GB │ IE
■
10
and
out. The
downwards and push the
into the appliance.
.
14a
Operation
Switching on and off
■
Direction of rotation of the tool!
■
Insert the plug into a mains power socket.
Switching on
♦
Press the ON/OFF switch
pressed.
Switching off
♦
Release the ON/OFF switch
Setting the cutting depth
WARNING! RISK OF INJURY!
►
Always remove the power plug from the
wall socket before carrying out any work on
the appliance.
♦
Adjust the screw on the cutting depth adjust-
ment
with the aid of the supplied hex key
(small)
.
♦
Test the cutting depth by lowering the motor
unit.
Changing the cutting disc
WARNING! RISK OF INJURY!
►
Always remove the power plug from the
wall socket before carrying out any work on
the appliance.
►
Allow the cutting disc
before you touch it
►
Check the cutting disc
damaged or damp, and it should have no
cracks. Otherwise, it could break during
use and cause injuries.
NOTE
►
Only use cutting disks which comply with the
performance data stated in this manual.
♦
Remove one of the mounting screws
supplied hex key (small)
mounting screw
protective cover
not remove the protective the cover
and keep it
.
to cool down
. It should not be
with the
. Loosen the other
so that you can slide the
to the side (see fig. A). Do
!
PMTS 180 B2
Publicidad
