Astralpool PRO-ELYO INVERTER 13 Manual Del Usuario página 20

to save the "Hour". Then the "
press the to save the current time setting , or press
Once you set the timer on successfully , the light
Timer off setting:
Press first ,then press the
again to enter into "HOUR" setting. The "Hour " flashes, and press the
press
to save the "Hour". Then the "
finally press the
Once you set the timer off successfully , the light
Cancel Timer ON/OFF
When you set Timer ON/OFF data 00:00, it means cancel the Timer ON/OFF function.
ATTENTION: Above operations, you could press
NOTE
In order to heat the water in the pool (or hot tub), the filter pump must be running to cause the
water to circulate through the heat pump. The heat pump will not start up if the water is not
circulating. If the water is not circulating and the Heat Pump is ON the LED controller inform
with the error code ON
Noted:
LED wire controller can operate the water pump after connected additional cable to the pump device in the
position of "PUMP" terminal accurately.
When HP stop running in 30 seconds, water pump will shut off automatically
6.2.4 System reset function
Minute" flashes, and press the
three times to enter into 'Timer off'' interface. Then press
Minute" flashes, and press the
to save the current time setting , or press
quick-exit the program.
or
for quick-exit and saving.
will display.
for quick-exit and saving.
will display.
to save the setting and
16
to set the "Minute" and finally
or to set the hour ,then
or to set the "Minute" and
once