Bosch SHE66C Manual De Uso Y Cuidado página 17

Care and Maintenance
To reinstall the top spray arm:
. Return the top spray arm to its installed
position.
2. Return the locking nut to its installed
position and turn it 1/8 turn clockwise.
. Return the top rack to the top rack roller
guides.
To remove the bottom spray arm:
. Remove the empty bottom rack from the
dishwasher tub.
Figure 
2. Grasp and lift the bottom spray arm as
shown in Figure 33.
. Look for obstruction in the spray nozzles.
. If the spray nozzles need cleaning, flush
them under running water.
To reinstall the bottom spray arm:
. Return the bottom spray arm to its installed
position and press it so that it snaps into
place.
2. Return the bottom rack to its installed
position.
(continued)
Check/Clean the Filter System
This dishwasher has a filter system that consists
of a Large Object Trap/Cylinder Filter assembly
and a Fine Filter. Select models have an
additional Micro Filter. The filter system is located
on the inside of your dishwasher under the lower
rack and is easily accessible.
During normal use, the filter system is
self-cleaning. You should occasionally inspect it
for foreign objects and clean it when necessary.
To Remove the large Object Trap/Cylinder
Filter Assembly:
. Remove the bottom rack.
2. Grasp the assembly as shown in Figure 34
and turn it counterclockwise 1/4 turn.
. Lift out the assembly as shown in Figure 35.
To avoid injury, do not reach into the large
object trap with your fingers. The large
object trap could contain sharp objects.
. Carefully examine the assembly. If you
find debris in the Large Object Trap, turn it
upside-down and gently tap it on a surface
such as a countertop to dislodge and remove
the debris. Flush the Cylinder Filter clean by
holding it under running water.
Figure 
Figure 5
CAUTION
Large
Object
Trap/
Cylinder
Filter
5