BEFORE REQUESTING SERVICE
WARNING
Electric Shock or Pereonal Infury Hazard.
Disconnect the electrical supply before servicing or cleaning the unit Failure to do
so could result in electric shock or personal injury from cleaner suddenly starting.
Review this chart to find do-it-yourself solutions for minor performance
problems. Any service needed, other than those described in these
Operating Instructions, should be performed by an authorized service
representative.
PROBLEM
POSSIBLE CAUSE
POSSIBLE SOLUTION
Cleaner will
not run.
1. Unplugged at wall outlet.
1.
Plug infirmly. Push On/Off
switch to On.
2. On/Off switch not turned on.
2. Push On/Off switch to On.
3. Tripped circuit breaker^rtjlown
fuse at household service panel.
3. Reset circuit breaker or replace
fuse.
Poor job of dirt
pickup.
1.
Full or clogged dust bag.
1.
Change bag.
2. Broken belt.
2. Replace belt.
3. Carpet height setting incorrect.
3. Set in the correct position.
4.
Clogged hose or nozzle.
4.
Clean hose or nozzle area.
5. Hose not inserted fully.
5. Insert hose.
6. Worn agitator.
6. Replace agitator.
7. Hole in hose.
7. Replace hose.
8. Dust cover improperly installed.
8. Properly install dust cover.
9. Belt not installed on motor shaft.
9. Install belt on motor shaft.
Dust escapes
the paper bag.
1.
Bag improperly installed.
1.
Properly install bag.
2. Bag torn.
2. Replace bag.
Light will
not work.
1. Burned out light bulb.
1.
Replace light bulb.
Cleaner picks up
moveable rugs or
pushes too hard-
1. Wrong carpet height setting.
1. Adjust setting.
-
18
-