Fitting The Handlebar; Fitting The Harness - Jonsered BC 2126 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ASSEMBLY
NOTE:
Make sure unit is assembled
cor-
rectly as shown
in this manual.
Fitting the handlebar
Remove
the screw at the rear of the
throttle
handle.
Slide the throttle handle onto the right
side of the handlebar
(see illustration).
Align the screw hole in the throttle
han-
dle with the hole in the handlebar.
Refit the screw in the hole in the rear of
the throttle handle.
Screw the screw
through the handle and
handlebar.
Tighten the screw.
Fit the mounting
components
as shown.
//
• The handlebar
mounth_g must be fitted
between
the arrows on the shaft.
• Tighten the screws
with a hex wrench.
Fitting the harness
I_ib
WARNING:
When using a
brushcutter,
it must always
be
hooked
securely
to the harness.
Otherwise,
you will be unable to
control the brushcutter
safely.
This can result in injury to yourself
or others.
Never use a harness with
a defective
quick release.
Proper harness
and handlebar
adjust-
ments must be made with the engine com-
pletely stopped
before using unit.
Fitting
the
harness
clamp
• Place the upper harness
clamp over the
shaft and position the lower harness
clamp under the shaft. Align the upper
and lower clamp screw holes. Clamp
must be fitted above the arrow on the
shaft (see illustration).
NOTE:
Fit throttle
wire in groove of lower
harness
clamp before tightenh_g screws.
• Insert two screws
h_to the screw
hotes.
• Secure harness
clamp by tightening
screws
with a hex wrench.
Adjusting
the
harness
• At the front of the harness is an easi]y
accesible quick release. Use the quick
release in any emergency
situation that
requires you to free yourself from the
machine and harness.
......
_.=-
j
Spreading
the
load
on your
shoulders
• A well-adjusted
harness
and machine
makes
work much easier.
• Put on the harness. Adjust
the harness
for the best working
position.
Tension the
side straps so that the weight is evenly
distributed
across
both shoulders.
NOTE:
it may be necessary
to relocate
the harness
clamp on the shaft for proper
batancing
of unit.

Publicidad

Tabla de contenido
loading

Tabla de contenido