Publicidad
Idiomas disponibles
Idiomas disponibles
Positioning, installation, repairs and modifications must only be
carried out by an AUTHORISED TECHNICIAN, in accordance with
the regulations in force in each country.
Improper installation, adjustment, servicing or maintenance of
the appliance or tampering with it may result in material damage
or injury.
10.3.1 Unpacking
Unpack the appliance and check that it has not been damaged in transit. If it is, notify
your supplier and the carrier immediately. If you are unsure, do not use the appliance
until the extent of the damage has been checked.
Packaging materials (such as plastics, expanded polyurethane, and staples) are potentially
dangerous, so keep them out of the reach of children.
Do not lay the appliance on its side. If it has been laid on its side, consult the
manufacturer about how to proceed. If this happens, after standing it upright, wait at
least 2 hours before turning it on.
Only manoeuvre the appliance using a forklift or similar device to avoid damaging its
structure. Transport the appliance to the place where you intend to install it before
unpacking.
The packaging materials are fully recyclable; dispose of them in the appropriate
container.
10.3.2 Positioning and levelling
Keep the area around the appliance clear and clean to prevent the refrigeration unit fan
from drawing in any materials that could become deposited on the condenser fins,
reducing the system's efficiency.
Remove the pallet, taking care not to knock the cabinet. You can now level the appliance
by screwing each of the feet up or down. When it is level, remove the protective film
from the stainless steel using a blunt tool. Do not use a knife that could scratch the
metal.
In its final position, ensure that there is a clearance of 60 mm between the unit and the
back wall, 30 mm from the sides, and 500 mm from the ceiling.
If the appliance is on wheels, ensure it is on a flat surface. At start-up, make sure that
there is no heat source nearby.
For optimum operation of the refrigeration system components, ensure that the air
intakes to the fan inside the cabinet and the condenser are not clogged or obstructed.
A: FOOT BODY
B: SCREW:
Turn to the right to lower the cabinet
Turn to the left to raise the cabinet
27
Publicidad
