Publicidad
Idiomas disponibles
Idiomas disponibles
Changing the filter: Unscrew the plate at the bottom of the appliance and remove the
10.4.3.3 Changing the UV-C light
Your appliance may be fitted with this option. To replace the lamp, first, unscrew and
remove the metal air deflector plate behind it. Once you have removed the plate, you
can access the UV-C lamp. Change the lamp and then screw the plates back where they
were before.
10.4.4 Faults & Alarms
In the event of any faults or malfunctions, follow the steps below. The following table
lists possible causes and possible solutions. If you are unsure or are unable to resolve
the problem, contact technical support.
Never touch electrical components yourself, as some are a mains voltage shock
risk and a danger to life.
POSSIBLE
FAULT
The unit is not
No voltage
working
Refrigerator
temperature
Position of the
meat inside the
Temperature
high
Door closure
Condenser
Poor levelling or
Strange
or
poor door closing
excessive noise
Friction with the
unit's moving
Loose fixings
NOTE: For any malfunction not listed in the table above, contact your
technical support service. The manufacturer reserves the right to modify
the characteristics without prior notice.
10.5 USEFUL TIPS
Read the following useful tips carefully to get the most out of your appliance.
cover. Remove the filter inside and replace it with a new one.
Screw the filter cover back on.
CAUSE
Check that voltage is supplied to the refrigerator by
checking that the display is on.
Check that there is no heat source nearby.
location
Check that the room temperature is not above +40°C, the
Room
unit's maximum operating temperature.
Check that the meat is correctly positioned and not blocking
the air outlets from the internal fan. Check that the meat has
cabinet
been in the cabinet long enough to cool sufficiently.
Check that the doors close properly.
Check that the condenser is clean: Remember that the
cleaner the unit is, especially the condenser fins, the less
cleanness
energy it uses. How often you need to clean it depends on
the characteristics of the premises. If it is dirty, call technical
service to clean it.
Check that the cabinet is level and that the doors close
tightly.
Check that no objects are rubbing against any of the unit's
moving parts.
parts
Check that all screws (at least the visible ones) are
adequately tightened.
SOLUTION
33
Publicidad
