Optimal temperature selection
Whilst wine is best stored at temperatures between 13 and 15˚ C, your
wine can also be stored at drinking temperature. For red wine this is be-
tween 15 and 17˚C, and for white wine between 12 and 13˚C.
Indoor lighting
Press and hold the light button for 5 seconds to turn the light on or off.
Activation is indicated a dot on the display.
Settings mode
Some settings are available depending on the mode.
Set the temperature unit °F or °C.
Touch and hold
to confirm. Touch
Set the display backlight intensity
Touch and hold
to set the display backlight intensity. The default setting is d1. Touch
to confirm. Touch
Set the appliance interior lighting intensity.
Touch and hold
to set the interior lighting intensity. The default setting is L3 Touch
confirm. Touch
Set sounds.
Touch and hold
and
to set the sounds. The default setting is S1. The possible settings
are as follows:
S0: Touch sensor sound ON / Audio alarm OFF
S1: Touch sensor sound ON / Audio alarm ON
S2: Touch sensor sound OFF / Audio alarm OFF
S3: Touch sensor sound OFF / Audio alarm ON
Touch
to confirm. Touch
Internal Humidity
According to the model wine coolers are equipped with a humidity sys-
tem to maintain optimal humidity within the wine cooler. Fill the humidity
reservoir approximately 3/4 full with water. Place the reservoir on the
runners on the top shelf as shown in fig. 2. Ensure it is located correctly
to prevent water spillage. Check the water level regularly and refill if
required.
Temperature display
The temperature display will show the current internal temperature.
The display flashes:
•
When a different temperature is being set
•
If the internal temperature is +/- 5˚ away from the set temperature.
This serves as a warning to prevent damage to the contents of the appli-
ance should the temperature be too high.
Silent Mode
Touch and hold
an
to set the silent mode (F0). When the required temperature is
reached, the appliance operates without the fan. This is the default mode
of the wine cooler.
for 5 seconds, then use
for 5 seconds to exit.
for 5 seconds, then touch
for 5 seconds to exit.
for 5 seconds, then touch
for 5 seconds to exit.
for 5 seconds, then touch
for 5 seconds to exit.
for 5 seconds, then touch
- 21 -
and
to set the unit. Touch
once. Now use
twice. Now use
four times. Now use
three times. Now use
and
and
to