Hinkley SWELL FLUSH 903456FWB-LDD Manual De Instrucciones página 12

INSTALLING THE LED ASSEMBLY AND GLASS SHADE
WARNING: Before starting installation, disconnect the power by
turning off the circuit breaker or removing the fuse at fuse box.
Turning power off using the fan switch is not sufficient to prevent
electric shock.
If you do not wish to install the light kit, skip this step and
proceed to next step.
Remove the 1 of 3 screws from the posts of the LED
1
assembly decorative housing and keep it for future use.
Loosen the other 2 screws. (Do not remove)
While holding the LED assembly under your fan, make the
2
polarize plug connections: (Fig. 1)
- White to white
- Black to blue
Place the key holes on the LED assembly over the 2 screws
3
previously loosened, turn the light plate until it locks in
place at the narrow section of the key holes. Secure by
tightening the 2 screws previously loosened and the one
previously removed. (Fig. 1)
Raise glass shade up against LED assembly and secure it
4
to the fan by turning the glass shade clockwise until snug.
DO NOT OVERTIGHTEN. (Fig. 2)
5
Restore power and your light kit is ready for operation.
| hinkley.com
10
Wire connectors
LED assembly
Fig. 1
Glass shade
Fig. 2
Adapter plate
Screws
LED assembly