Hinkley SWELL FLUSH 903456FWB-LDD Manual De Instrucciones página 8

HANGING THE FAN
REMEMBER to turn off the power. Follow the steps below to hang
your fan properly.
Carefully lift fan motor assembly (without the blades) into position
by hanging the motor assembly onto the hook from the ceiling
mounting plate allowing it to hang freely. (Fig. 1)
INSTALLATION OF SAFETY CABLE SUPPORT
Attach the wood screw and the flat washer to the ceiling joist as
shown (do not fully tighten). Slide the cable clamp onto the safety
cable from the fan. Loop the safety cable around the wood screw
that was just attached to ceiling joist. Feed the end of the cable
into the clamp and pull as much cable through as possible. Firmly
tighten screw in the clamp. Cut off excess cable and tighten the
wood screw to ceiling joist. (Fig. 2)
You are now ready to make the electrical connections.
| hinkley.com
06
Outlet box
Fan motor
assembly
Fig. 1
Safety cable clamp
Safety cable loop
Wood screw and washer
Safety cable
Fig. 2
Hook
Wood ceiling joist