Husqvarna TS 300 E Manual Del Usuario página 15

Problem
The water pump does not start.
The water pump stops to pump
water.
To do before transportation, storage
and disposal
1. Stop the product. Refer to
page 12 .
2. Disconnect the power cord.
3. Empty the water tray through the hole in the bottom
of the water tray.
4. Pull out the locking hook and push the locking hook
to the right to put it in the locked position.
2282 - 002 - 07.02.2024
Solution
Make sure that the hose is connected and not damaged.
Make sure that there is voltage in water pump circuit and mains supply.
Make sure the hose to the water pump is connected.
Make sure the valve on the water pump is set to the correct position.
Make sure that the water pump is clean. Refer to
page 14 .
Take out the water pump from the water and put it back.
Transportation, storage and disposal
To stop the product on
To move the product
1. Fold the rear frame legs.
2. Fold the front frame legs and put the product on the
surface.
To clean the water pump on
15