Husqvarna TS 300 E Manual Del Usuario página 9

Water pump
The water pump (A) of the water system is used to
decrease the quantity of dust and keep the blade cool.
CAUTION:
dry.
• The water pump may only be used together with the
products in this manual.
• The water pump must be used in accordance with
the directions in this manual.
To do a check of the water pump
1. Fill the frame with water. Refer to
with water on page 11 .
Introduction
WARNING:
safety chapter before you assemble the
product.
To assemble the product
1. Put the conveyor cart (A) onto the frame (B).
A
B
2282 - 002 - 07.02.2024
A
Do not run the water pump
To fill the frame
Read and understand the
2. Push the ON button on the product to engage the
water pump.
Safety instructions for maintenance
• Use personal protective equipment. Refer to
Personal protective equipment on page 7 .
• Only do the maintenance given in this operator's
manual. Let an approved service agent do all other
servicing.
• Clean the product to remove dangerous material
before you do the maintenance.
• Do not use a high-pressure washer to clean the
product.
• Do not use water to clean the motor and electric
parts.
• Before you do the maintenance, push the OFF
button and disconnect the power plug.
• Replace damaged, worn or broken parts.
• Always use original accessories and spare parts.
Accessories and spare parts that are not approved
by the manufacturer, can cause serious injury or
death.
• Let an approved service agent do servicing on the
product regularly.
• If the maintenance is not done correctly and
regularly, the risk of injury and damage to the
product increases.
• Do the maintenance to make sure that the product
operates correctly. Refer to
13 .
Assembly
2. Make sure that the wheels of the conveyor cart
moves freely along the sides of the frame.
To install the cutting blade
WARNING:
from the power supply.
CAUTION:
counterclockwaise thread.
Introduction on page
Disconnect the power plug
The locknut of the blade is
9