Husqvarna TS 300 E Manual Del Usuario página 6

product away from rain. Water that goes into the
product increases the risk of electrical shock.
• Only connect the product to correctly grounded
outlet.
• Always disconnect the power cord before you
connect or disconnect the connection for the motor
cable and the electrical enclosure.
Grounded product instructions
WARNING:
result in electrical shock. Speak to an
approved electrician if you are not sure if
your mains outlet is correctly grounded.
Do not do modifications to the power plug
from its factory specification. If the power
plug or power cord is damaged or must be
replaced, speak to your Husqvarna service
agent. Obey local regulations and laws.
If you do not fully understand the
instructions about the grounded product,
speak to an approved electrician.
Use only grounded outdoor extension cables with
grounding plugs and grounding outlet that accepts the
product power plug.
The product has a grounded power plug. Always
connect the product to a grounded mains outlet. This
decreases the risk of electrical shock if there is a
malfunction.
Do not use electrical adapters with the product.
Extension cables
• Use only approved extension cables with approved
length that fullfils the requirements. Refer to
Extension cables on page 20 .
• The rated value on the extension cable must be the
same or higher than given on the rating plate of the
product.
• Use grounded extension cables.
• When you operate the product outdoors, use
an extension cable that is applicable for outdoor
operation. This decreases the risk of electrical
shock.
• Keep the connection to the extension cable dry and
off the ground.
• Keep the extension cable away from heat, oil, sharp
edges or moving parts. A damaged cable increases
the risk of electrical shock.
• Make sure that the extension cable is in good
condition and not damaged.
• Do not use the extension cable while it is wound up.
This can cause the extension cable to become too
hot.
6
Incorrect connection can
Safety instructions for assembly
WARNING:
instructions that follow before you assemble
the product.
• Always use protective gloves when you assemble
the product.
• Make sure that the product is on a surface that is
flat and stable. Surface that is not flat and stable
increases the risk for the saw to tilt or move.
• Make sure that you push the OFF button and that
the product is OFF.
• Make sure that the power plug is disconnected.
• Make sure that the cutting blade does not move.
• Always use accessories that are approved by the
manufacturer.
• Make sure that the cutting blade, blade guard, blade
flange and blade shaft are not damaged.
Safety instructions for operation
WARNING:
and all instructions. Failure to follow the
warnings and instructions may result in
electrical shock, fire and/or serious injury.
• Use personal protective equipment. Refer to
Personal protective equipment on page 7 .
• The information in this manual is not a replacement
for professional knowledge and experience. If you do
not feel safe in the situation that you are in, stop
the product. Do not use the product in unknown
situations.
• Turn to your servicing dealer or Husqvarna if you
have questions about the operation of the product.
We can give you information about how to operate
your product safely with best result.
• Do not operate the product unless you receive
training before use. Make sure that all operators
receive training.
• Make sure that you always can stop the product
quickly in an emergency.
• Do not use the product if you are tired, ill, or under
the influence of alcohol, drugs or medicine.
• Sudden appearance of persons and animals can
prevent safe operation of the product. Always
operate the product carefully.
• Prevent accidental start. Make sure to push the OFF
button.
• Before you go away from the product, stop the motor
and disconnect the power cord. Make sure that there
is no risk of accidental start.
• Do not use a product that has been changed from its
factory specification.
• Make sure your tools are sharp and clean in order
to enable safer work. Refer to
13 .
Read the warning
Read all safety warnings
Introduction on page
2282 - 002 - 07.02.2024