Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY WARNINGS – READ BEFORE USING
ARC Rays can injure eyes and burn skin
Before welding, always inspect helmet and filter
•
lens to be sure they are fitted properly, in good
condition and not damaged.
Check to see that the clear lens is clean and
•
securely attached to the helmet.
Always wear safety glasses or goggles under the welding
•
helmet and protective clothing to protect your skin from
radiation, burns and spatter.
Ensure that optical radiation from other welder's arcs in the
•
immediate area does not enter in from behind the helmet and
auto-darkening filter.
Note: Auto-darkening filters in Lincoln helmets are designed to
protect the user against harmful ultra-violet and infrared rays both
in the dark and light states. No matter what shade the filter is set
to, the UV/IR protection is always present.
FUMES AND GASES can be dangerous
to your health.
Keep your head out of fumes.
•
Use enough ventilation or exhaust at the arc or
•
both to keep fumes and gases from your breathing zone and
general area.
When welding with electrodes which require special
•
ventilation such as stainless or hard facing (see instructions
on container or MSDS) or on lead or cadmium plated steel
and other metals or coatings which produce highly toxic
fumes, keep exposure as low as possible and within
applicable OSHA PEL and ACGIH TLV limits using local
exhaust or mechanical ventilation. In confined spaces or in
some circumstances, outdoors, a respirator may be required.
Additional precautions are also required when welding on
galvanized steel.
Refer to http://www.lincolnelectric.com/
safety for additional safety information.
WARNING
1
Publicidad
