Publicidad
Idiomas disponibles
Idiomas disponibles
Headgear Adjustment
Crown
Adjustment
Fore-Aft
Adjustment
HEAD SIZE ADJUSTMENT:
pushing in the Ratchet Knob and turning to adjust for the desired head size.
This knob is located at the back of the helmet.
ADJUSTMENT is made by adjusting for comfort and snapping the pin into
the hole to lock se-curely in place.
TILT: Tilt adjustment is located on the right side of helmet. Loosen the right
headgear tension knob and push the top end of the adjustment lever
outward until the lever's Stop Tab clears the notches. Then rotate the lever
forward or back to the desired tilt position. The Stop will automatically
engage again when released locking the helmet into position.
FORE / AFT ADJUSTMENT: Adjusts the distance between the user's face
and the lens. To adjust, loosen the outside tension knobs and slide forward
or back to the desired position and retighten. NOTE: Make sure both sides
are equally positioned for proper operation.
OPERATING INSTRUCTIONS
Tilt
Adjustment
HEADGEAR TIGHTNESS is adjusted by
Ratchet
Knob
4
HEADGEAR CROWN
Publicidad
