Quick Installa On Guide - Gallagher 3E3115 Instrucciones

Gallagher 3E3115 Alarm System User Manual
QUICK INSTALLATION GUIDE
The following steps show how to quickly get the Alarm system up and running.
Step Standard mode
Set to standard mode. See
Zone Address Se ngs (p. 7).
1
Mount to the wall and connect
the high voltage fence return
and earth (ground) terminals.
2
Connect to AC adaptor power supply
3
4 Op onal connec ons:
•
•
•
•
5 Turn the Energizer and Alarm System ON.
6 Pressing the On/Off bu on arms/disarms the alarm.
SMS
Controller
Energizer
Via RJ12 cable to i-Series system,
or to an SMS Energizer controller
if in standard mode.
Relay 1 output to the
Gallagher strobe light
Relay 2 output to the
Gallagher siren
12V ba ery
Alarm System
i-Series mode
If zone 6 is already used in the exis ng
i-Series system, then the Alarm system zone
has to be set to any other available zone
se ng. See Zone Address Se ngs (p. 7)
To earth/ ground
To fence
5