Adler europe AD 7051 Manual De Uso página 6

19. Do not aim the vacuum cleaner toward other people or animals.
20. The vacuum cleaner may be used only on dry surfaces.
21. Only use accessories designed for this appliance.
22. Use extra care when vacuuming stairs.
23. Do not block any vents.
24. Do not operate the vacuum cleaner without the filter.
25. Do not pull the vacuum cleaner by the hose.
26. Make sure that the power cord is not wedged by a door and does not get jammed.
When moving the vacuum cleaner please note the length of the power cord. Pulling the
vacuum cleaner suddenly when the cord is taut may damage it.
27.Vacuuming dust and residues of construction causes immediate loss of warranty. The
vacuum cleaner is designed for domestic use only.
28. The device is outfitted with a rechargeable battery. Do not throw into a fire, puncture,
crush or damage the battery.
Device Description: (Handheld vacuum cleaner)
1.Charging socket 2.Dust tank button 3.Dust tank 4.Dust tank release button 5.LED floor brush 6.Handle 7.Switch on/off button 8.Speed
control button 9.Battery indicator 10.Outlet 11.Tube release button 12.Tube 13.Floor brush release button 14.Wall hanger
15.Adaptor 16.2 in 1 crevice brush
·BATTERIE UNIT
To remove the battery unit from the device press the button on the indise of the handle as presented on Figure 2 page 3 in this manual.
CONNECTION OF BRUSH
Insert the upper part into the lower connection of the power tube and can hear the sound of locking.
CONNECTION WITH TUBE
Insert the upper ends into the main hole of the dust cup and can hear the locking sound
Connection of power brush and main machine
Insert the upper part of the power brush into the main hole of the main machine
·Connection of accessory brushes with main machine
Insert the accessory brushes into the main hole of the main vacuum cleaners
·LOW SPEED, HIGH SPEED, OFF (FIG. 5)
To turn the device On/OFF press the On/OFF button (E)
Use the TURBO button (D) to shift the speed from low to high.
·Vacuum cleaner charging
Please use the designated adaptor to charge the vacuum cleaner
Plug the adaptor into the charging slot located in the back opf the device near the handle. The indicator will start blinking during
charging.
Once fully charged the indicator light will stay turned on.
You can recharge the batteries unit alone or with the machine.
Clean after each use (FIG.6)
Press the lower button to release the dust cup lower cover. It is recommended to clean the dust cup after using it every time.
Dust cup cleaning (Fig. 2)
a) Press the button to release the lower cover of the dust cup to empty the dust
b) Take out the filter and clean or change it.
c) Clean the filter under running water and dry it under sunlight
·Cleaning of the power brush (FIG .7)
1, slide the lock chip on the back of the brush.
6