Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION: BACK POWER FEED
Wall Mounting
(Figure 2)
1. Using flat screw driver pry off front cover from back plate
(Figure 1).
2. Remove appropriate knockouts in back plate.
3. Feed wires through the hole.
4. Secure backplate to Junction Box.
5. Connect the Junction Box wires to the power supply wires
using the wire nuts provided. Connect the white wire to
neutral. If using 120V, connect the black wire to the hot
lead. If using 277V, connect the orange wire to the hot lead.
Cap the unused lead. Press the wires into the Junction Box,
refer to Wiring Diagram on page 1.
6. Connect remote heads. Refer to Connecting Remote
Heads below.
7. Connect battery connector (Figure 2).
8. Snap the front cover onto the back plate.
9. Restore power and press test button. LED heads will
turn on.
10. Adjust the lamp heads and lens direction as needed.
INSTALLATION: TOP POWER FEED
Ceiling Mounting
(Figure 3)
1. Refer to Back Power Feed: Wall Mounting installation
above.
2. Mount back plate on the ceiling surface instead of wall
surface. Feed building AC supply wire through back plate
then connect to fixture power supply wires using wire
nuts provided.
Wall Mounting
(Figure 4)
1. Open front cover and remove top knockout on the top
flange of fixture.
2. Secure conduit (or surface raceway) to knockout and feed
wires.
3. Remove keyhole knockout on back plate and mount to wall.
4. Refer to steps 5–10 above in Back Power Feed: Wall
Mounting.
Connecting Remote Heads
If fixture has remote capability option, maximum remote
capability is 3.6V DC, 1.5W.
Attach remote wire on remote connector on PCBA.
Connect remote heads extension wire to remote wire, yellow
is positive (+), purple is negative (–). Connect wires using
wire nuts.
(Figure 2)
Figure 1
Figure 2
Figure 3
Figure 4
2
Publicidad
