Satco Nuvo 67-100 Guía Rápida

LED EXIT SIGNS
AC ONLY AND SELF-POWERED LED EXIT SIGNS
Models: 67-100, 67-101
INSTALLATION AND SAFETY INSTRUCTIONS
IMPORTANT: Read before installing fixture. Retain for future reference.
WARNING: Risk of Fire or Electric Shock
• Disconnect power before installation or any maintenance of the fixture.
• To avoid damage, falling, electric shock or fire, do not modify the
fixture or replace accessories.
• Only authorized, qualified personnel should install this fixture and
should follow the owner's manual.
• Do not dismantle the fixture.
• Do not touch the power supply when the fixture is operating.
• For use in environments where an accumulation of non-conductive
dust on the fixture may be expected.
• Damp rated. Do not use outdoors.
• Do not mount near gas or electric heaters.
• Do not let power cords touch hot surfaces.
• Use caution when servicing batteries. Avoid possible shorting.
• Equipment should be mounted in locations and at heights where it will not readily
be subjected to tampering by unauthorized personnel.
• The use of accessory equipment is not recommended and may cause an unsafe
condition.
• Do not use this equipment for other than intended use.
• Before wiring to AC service, turn off AC power at fuse or circuit breaker.
• Disconnect AC power and unplug battery before servicing.
• Battery in this unit may not be fully charged. After the AC service is supplied to
unit, let the battery charge up for at least 24 hours before performing any tests.
IMPORTANT:
This product must be installed in accordance with the applicable
installation code by a person familiar with the construction and operation of the
product and the hazards involved.
MAINTENANCE: (For battery backup item)
Battery may need to recharge upon initial power up. We recommend that the equipment be tested regularly in accordance with local
codes. Replace the batteries as needed if discharge time does not achieve 90 minutes.
OPERATION: (For battery backup item)
Press the test button, unit luminance by battery backup and the LED indicator will turn off, release the test switch, LED indicator will
turn on.
ASSEMBLING CANOPY TO HOUSING:
Insert canopy into housing at a 20 degree angle and twist.
Quick snap is now firmly locked.
CAUTION:
Trying to remove
canopy after it is locked in
place may cause damage.
MANUAL TESTING:
1) Manual test switch
2) LED indicator (indicates normal
operation)
© Copyright 2023 Satco Products, Inc. 3/23 v1.3
PARTS DESCRIPTION
1) Plastic housing
2) EXIT panel
3) Back plate
4) Mounting hole cover
5) Snap in directional arrow
6) Red or green diffuser
7) Canopy
8) Canopy screws
9) Wire nuts
10) Junction Box (building utility)
11) Crossbar
12) Crossbar screws (not provided)
CAUTION:
Battery connector is shipped disconnected.
It must be connected at installation.
OPENING EXIT PANEL:
flat blade screwdriver to open. Insert
screwdriver into the slot and gently
pry off the panel.
1
67-100: Green 67-101: Red
WIRING DIAGRAM
Use
Satco Products, Inc.
Brentwood, NY 11717