Detent Override; Sliding Base/Fence Extension - Bosch 3915 Instrucciones De Funcionamiento Y Seguridad

Basic Saw Operations
To Engage:
1. Lift the miter detent trigger.
2. Push the detent override clip forward and latch in
place over edge. Release miter detent trigger
(Figure 25).
3. Move miter arm to any position on the miter
scale.
4. Lock the miter lock knob to retain miter position.
To Disengage:
5. Loosen miter lock knob and lift the miter detent
trigger to release the detent override clip. The
clip should automatically disengage and the
table should lock into any desired miter detent.
Extend and use sliding base/fence
WARNING
!
when making severe bevel, severe
miter or compound cuts to provide sufficient (mini-
mum 6") spacing from hand to saw blade.
1. Remove hex wrench from storage position on
left rear leg.
2. Loosen two (2) socket cap screws in sliding
base channel (Figure 26).
3. Extend sliding base/fence to the desired posi-
tion.
4. Tighten screws. Store hex wrench.
During transportation, sliding base
WARNING
!
should always be secured in the full
in position.

Detent Override

Sliding Base/Fence Extension

Detent Override Clip
Table
Miter Detent
Trigger
Figure 25. Detent Override
Sliding
Base/Fence
Socket Cap
Screws
Figure 26. Sliding Base/Fence
22.
Clip Edge
Miter Lock
Knob
35
30
20
15