Special Cuts; Cutting Bowed Material; Cutting Round Or Irregularly Shaped Material - Bosch 3915 Instrucciones De Funcionamiento Y Seguridad

Cutting bowed material and round material are only
examples of special cuts.

Cutting Bowed Material

If workpiece is bowed or warped,
WARNING
!
clamp it with the outside bowed face
toward the fence. Always make certain that there is no
gap between the workpiece, fence and table along the
line of cut. Bent or warped workpieces can twist or
rock and may cause binding on the spinning saw
blade while cutting (Figure 36).
Cutting Round or Irregularly
Shaped Material
For round material such as dowel
WARNING
!
rods or tubing, always use a clamp
or a fixture designed to clamp the workpiece firmly
against the fence and table. Rods have a tendency to
roll while being cut, causing the blade to "bite" and pull
the work with your hand into the blade (Figure 37).
Saw Operations

Special Cuts

30.
Workpiece
Clamp
Fence
Bowed Material
Figure 36. Bowed Material
Workpiece
Clamp
Fence
Round Material
Figure 37. Round Material
No Gap at
this Point