Using Miter Detent System; Miter Detent Override; Engaging The Miter Detent Override; Disengaging The Miter Detent Override - Bosch CM10GD Instrucciones De Funcionamiento Y Seguridad

Ocultar thumbs Ver también para CM10GD:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

2610051885.qxp_CM10GD 12/3/18 8:49 AM Page 38

▶ Using Miter Detent System

1. Loosen the miter lock knob about 1/2 turn.
2. Grip the lock knob, and then reach down
with your index finger to pull up on the
miter detent lever – pull lever until it is out
from the detent plate.
3. While gripping the lock knob and lever,
rotate the saw's table. Stop table rotation
at the desired angle as indicated by the
miter scale pointer.
4. Release the lever into a detent in the detent
plate or at an angle between detents. If
close to a detent, use the detent override
feature.
5. Tighten the miter lock knob before cutting.

▶ Miter Detent Override

The miter detent override system locks out
the automatic detent action. When the
desired miter angle is close to a standard
detent slot, this feature will hold the detent
lever wedge from engagement (i.e., the user
wants to be at 44-1/2°, but detent wedge
wants to pop into the 45° detent). When the
detent override is used, the detent system is
disabled and the table will move smoothly to
any position within its range.
▼ ENGAGING THE MITER DETENT
OVERRIDE
1. Pull up and hold the miter detent lever – the
lever is located under the turntable's front
arm (see Figure 41).
2. Press down on the top half of the detent
override button and then release hold of the
detent lever. The override button will
remain in the DOWN position (see Figure
41).
3. The turntable is free to rotate.
knob must be tightened before attempting
any cutting.
Saw Operations
With the table free to
rotate, the miter lock
Miter Scale
Pointer
Detent
Detents
Plate
Miter Detent Lever
Miter Lock Knob
Figure 40
▼ DISENGAGING THE MITER DETENT
OVERRIDE
1. Pull up the miter detent lever and the detent
override
system
disengage. The override button will return
to the UP position.
2. Loosen the miter lock knob to allow the
table to rotate to a new position – the
detent lever is now free to engage the
preset detent slots.
Detents
Miter Detent Lever
Miter Lock Knob
Figure 41. Detent Override
38
will
automatically
Detent
Override
Button

Publicidad

Tabla de contenido
loading

Tabla de contenido