Special Cuts - Bosch CM12 Instrucciones De Funcionamiento Y Seguridad

BM 2610021316 10-11 E:BM 2610021316 10-11 E.qxp 10/17/11 11:02 AM Page 32
Cutting bowed material and round material are
only two examples of special cuts.
Cutting Bowed Material
If workpiece is bowed or
WARNING
warped, clamp it with the out-
side bowed face toward the fence. Always
make certain that there is no gap between the
workpiece, fence and table along the line of
cut. Bent or warped workpieces can twist or rock
and may cause binding on the spinning saw blade
while cutting (Figure 46).
Saw Operations
Stationary
Saw Base
Fence
Saw Operations
FIG. 45
New Auxiliary Fence
(assembled to Miter Saw)
Top of Base
and Table

Special Cuts

fence
-32-
FIG. 46
Material
clamp
Bowed
Material