Ferroli RIMINI DP Serie Instrucciones De Instalación, Uso Y Mantenimiento página 58

RIMINI DP
The current half-hour interval flashes to indicate to the user
what time the current set point is taken from.
Additionally, the current time operating mode symbol (the
sun, the moon or the ice icon) is displayed in the lower left
corner of the screen.
See section 5.5 "Edit day, time and program" to modify the program used in this mode.
Adaptive start control can be applied to Program mode and can be enabled or disabled in Con-
figuration mode (see section 5.8 of the manual for details of the Adaptive start control function).
Program mode is the only mode in which this function operates.
FIL PILOTE:
In this "Fil Pilote" mode, the electric thermal emitter would
automatically follow the orders from the pilot wire control
unit. In the case of the RIMINI DP emitter, in this mode it
always works the same as in Comfort mode.
CONFIGURATION:
The Configuration screen is at the end of the modes sequence, before enter-
ing back to the initial Comfort mode. Allows the user to set parameters and
functions for the other modes.
You can configure 4 parameters; the active parameter is flashing:
1 - Brightness level at rest, from 0 to MAXIMUM (100%)
2 - Maximum brightness time, from 1 to 240 seconds
3 - Open Windows function, ON or OFF
4 - Adaptive start control function, ON or OFF
To modify a parameter, use the and keys. To move from one parameter to the next, touch
the OK key. The system exits this screen by touching the mode key at any time, by waiting 30
seconds without touching any key or by touching the OK key on the last parameter.
5.4. Heating and Temperature display
The room temperature is normally shown on the display; the set point temperature is only dis-
played when the user attempts to change it; after the setting has been adjusted the display will
revert back to the room temperature.
The comfort and eco set point temperatures can be modified both from Comfort and Economy
modes, and also within Program mode if they are active at the time (the anti-frost set point can
never be modified).
EN
58 A73021554