Ferroli RIMINI DP Serie Instrucciones De Instalación, Uso Y Mantenimiento página 62

When Adaptive Start is running the emitter progressively increases the set-point temperature
until the next programmed set point is reached.
* This function is considered by Directive 2009/125/EC regulations and will give the unit
more efficiency during operation.
5.9. Keyboard lock
The user can lock the keyboard by touching and holding the
and keys for 2.5 seconds. The un-lock is performed in the
same way. When the touchpad is unlocked or locked, the
screens are displayed:
This is possible in all modes of operation except in Configuration. The emitter can be also
locked when is on Standby.
When the emitter is locked, the padlock icon will appear in the
upper left area of the screen:
6. ERRORS TABLE
There are 3 types of errors that the electronics can detect; if an error is detected one of the
codes below will be displayed on the screen until it is resolved.
ERROR
DESCRIPTION
CODE
ERROR1 Failure in microcontroller or RTC (problems with the current time)
ERROR2 Failure of the NTC probe (e.g., disconnected, short-circuited, etc.)
ERROR3 Failure of the EPROM memory
When recovering from an error, the emitter will always return to Standby mode and will not re-
tain any previous mode or state. If the emitter goes to Standby without any specific reason, it
may have recovered from an error.
7. MAINTENANCE AND CARE
RIMINI DP electric thermal emitters require very little maintenance. In order to clean the emitter,
it is recommended that the electric power is turned off. Wipe the outside of the thermal emitter
and clean its inside channels with an appropriate brush.
The surfaces of the emitter must not be cleaned with an abrasive product or those containing
granular substances. We recommend regular cleaning with PH neutral products.
Failure to keep the RIMINI DP emitter clean may result in dust becoming burnt and depositing
on the wall above the emitter in the form of dark streaks or patches. This type of marking is ex-
pressly due to failure to keep the emitter and surrounding area clean.
FERROLI take no responsibility for any such damage caused.
62
EN
RIMINI DP
A73021554