USER MAINTENANCE INSTRUCTIONS
REPLACEMENT (REMOVAL) OF BLADE SET
To remove blade set from your trimmer, make sure the trimmer is in the
OFF
the
smaller
trimmer housing. Replace with new cutting system and reverse the removal
procedure, only this time, place your thumb on the large cutter and snap into place.
MAINTENANCE OF THE BLADE
Always apply oil to the blades before and after use. This will ensure maximum cutting per-
formance. Hold trimmer away from your body in a downward position and apply oil on the
front and sides of the cutter blade. Wipe excess oil off with a soft, dry cloth.
BLADE CARE
Because the trimmer blades are precision-made for a very special use, they should always
be handled with care and cleaned regularly to ensure maximum performance. Each time you finish using
the trimmer, take the cleaning brush provided and brush away any loose hair that has collected in the
blades. Use a clean cloth to dry the attachment, reattach and then store the trimmer to protect the blades
until the next use.
Any other servicing should be performed by an authorized service representative, since the appliance
has no other user-serviceable parts. This product is for commercial use.
DISPOSAL OF LITHIUM ION POLYMER BATTERY
This trimmer has a lithium ion polymer battery. To protect the environment, these batteries should be
removed and properly disposed of when the unit is no longer operating. To remove the battery block for
disposal or recovery, follow these instructions:
1. Disconnect the trimmer from household outlet.
2. Discharge the battery pack completely before removing.
3. Remove the blade and 5 screws. NOTE: One screw is located under the rating label.
4. Open cover.
5. Remove the screw that fastens the printed circuit board to housing. Lift printed circuit board out.
6. Unplug lithium ion polymer battery.
7. To protect the environment, do not dispose of your battery with your ordinary household waste.
For more details on recovery of material and waste-treatment facilities, please contact the waste dis-
posal services in your region.
CONTAINS LITHIUM ION POLYMER BATTERY.
MUST BE COLLECTED, RECYCLED OR DISPOSED
OF PROPERLY. DO NOT DISPOSE OF IN THE
MUNICIPAL WASTE.
T-blade
Fig.1
position.
Remove
cutter
and
Trimmer
Switch
the
blade
set
pushing
forward,
Fig.3
by
placing
thumb
releasing
the
cutter
Charger
against
from
the