Descargar Imprimir esta página

Jocel JCAV003621 Manual De Instrucciones página 49

Vinoteca
Ocultar thumbs Ver también para JCAV003621:

Publicidad

Idiomas disponibles

Idiomas disponibles

K1: ON/OFF
Press the key to start or turn off the appliance.
K2: LIGHT
Press the key to turn on / off the inside light.
K3: SELECT THE STORAGE AREA
Press this key to select the top or bottom zone.
L1: VIEW TEMPERATURE BY SELECTED AREA
Temperature display:
A: Top zone: 5-12 ˚C
B: Bottom zone: 12-18 ˚C
Note: Symbol "%" in the lower right corner means humidity. It is not applicable to this
product/model you purchased.
K4: INCREASE TEMPERATURE
Press the key once, the LED display will flash indicating the current temperature. Press again to
set the temperature. One touch will increase the temperature by one degree. The blink stops after
5 seconds without action on your part, and the newly set temperature is recorded. The LED display
then shows the actual temperature inside.
K5: DECREASE TEMPERATURE
Press the key once, the LED display will flash indicating the current temperature. Press again to
set the temperature. One touch will reduce the temperature by one degree. The blink stops after
5 seconds without action on your part, and the newly set temperature is recorded. The LED display
then shows the actual temperature inside.
K6: SETTINGS
FAHRENHEIT/CELSIUS
Switch the temperature display between Fahrenheit/Celsius by pressing the key.
There are two internal fans for airflow however fluctuations of up to 3 degrees is expected. The
average temperature throughout the appliance will be a maximum of 1.5˚C of the requested
temperature (once sufficient time for cooling has passed). Once a temperature difference of 3˚C
above the set temperature is detected, the cooling cycle will start to bring the temperature down
to below the set temperature. Once the cooler temperature is reached, the cooling stops and the
temperature inside the appliance is allowed to slowly increase. This cycle is continuous and results
in a very small range of constant fluctuation.
The temperature sensor is placed halfway down the compartment and reads the temperature
instantaneously. Small amounts of deviation in temperature are expected (less than 6˚C).
Please do not open the door too often as this will disrupt the operation of the temperature sensors.
The appliance automatically adjusts moisture and condensation levels within the appliance as
required.
49

Publicidad

loading