HP Color LaserJet Pro MFP 4303dw Serie Guía De Referencia página 3

Printer features
1 2 3
Front
1 Walk-up USB port (wireless models only)
2 Output tray extender
3 Output tray
4 Control panel
5 Automatic document feeder
6 Power button
7 Tray 1/Toner access door
8 Tray 2
During Setup: Help and tips for Wi-Fi and connectivity
If the software is unable to find your printer during setup, check the following conditions to resolve
the issue.
Potential Issue
Printer Wi-Fi setup mode timed out
Computer too far from printer
Computer connected to a Virtual Private
Network (VPN) or remote work network
Wi-Fi turned off on computer
(computer connected by Ethernet)
4
5
6
7
8
9
10
Back
9 Rear door
10 Power connection
11 Access toner cartridges
12 USB port for computer connection
13 Ethernet port
14 USB port for Job Storage
15 Fax port: Fax "line in"*
16 Fax port: Telephone "line out"*
Solution
Check the control panel, and restart wireless
setup mode, if prompted.
Move your computer closer to the printer. Your
computer might be out of range of the printer's
Wi-Fi signal.
Disconnect from a VPN before installing HP
printer software. Connect to the VPN again after
finishing printer setup.
Note: Consider your location and the security
of the Wi-Fi network before disconnecting
from a VPN.
If your computer is connected by Ethernet,
turn on the computer's Wi-Fi while setting up
the printer. You don't need to disconnect the
Ethernet cable from the printer.
11
12
13
14
15
16
* Fax models only
3