SpeedEPart Agri-Fab 45-02992 Manual Del Usuario página 5

6. Assemble a 2.38" long spacer (S), a 3/4" flat washer
(O), the middle brace, a 3/4" flat washer (O) and a
3.90" long spacer (Q) onto the long end of the shaft.
The bent lip of the middle brace must face the short
end of the shaft. Next assemble a spool assembly,
a 5.29" long spacer (T), another spool assembly, a
1.00" long spacer (R) and a 3/4" flat washer (O) onto
the shaft. See figure 4.
MIDDLE
2.38" LONG
BRACE
SPACER (S)
3.90" LONG
SPACER (Q)
3/4" FLAT
WASHER (O)
5.29" LONG
SPACER (T)
FIGURE 4
7. Rotate the wheel bracket fastened to the middle of
the shaft so that it is pointing upward. Assemble an
end plate, a 3/4" flat washer (O) and a second wheel
bracket onto the long end of the shaft. Point this
wheel bracket as shown in figure 5. Secure it to the
shaft using a 1/4" x 1-3/4" hex bolt (B) and 1/4" nylock
nut (L). Tighten. Repeat on short end of shaft.
MIDDLE WHEEL BRACKET
POINTING UP
3/4" FLAT WASHER (O)
1/4" NYLOCK NUT (L)
FIGURE 5
LONG END
OF SHAFT
3/4" FLAT
WASHER (O)
1.00" LONG
SPACER (R)
1/4" x 1-3/4"
HEX BOLT (B)
ENGLISH
8. Assemble a wheel to a wheel bracket using a 1/2" x
3-1/2" hex bolt (A), two 1/2" washers (P), a 1/2" jam
nut (M) and a 1/2" nylock jam nut (I). Adjust the nuts
so that the wheel is held securely but will spin freely.
Repeat on other side. See figure 6.
1/2" NYLOCK
JAM NUT (I)
1/2"JAM NUT (M)
FIGURE 6
9. Assemble the hitch bracket to the tongue using
two 3/8" x 1" hex bolts (D) and 3/8" nylock nuts (J).
Tighten. See figure 7.
10. Assemble the hitch pin (G) through the hitch bracket
and the tongue. Secure it with the hair cotter pin (H).
See figure 7.
HITCH
PIN (G)
FIGURE 7
5
1/2" WASHER (P)
1/2" WASHER (P)
3/8" x 1"
HEX BOLT (D)
3/8" NYLOCK NUT (J)
HAIR COTTER PIN (H)
1/2" x 3-1/2"
HEX BOLT (A)